Abstract
A pot experiment was conducted at the Agric. Exp. Station of El-Mansoura Univ. during the winter season of (2013/ 2014); to investigate the effect of some amendments on calcareous soil using sugar peas (Pisum sativum var . macrocarpon) variety of "mangetout"" ,type (Snow wind). Thirteen treatments were arranged in a complete block design, which were the simple possible combination between four treatments of soil amendments application (Magnetite (100, 200 and 300 kg fed-1), Sulphur (200, 300 and 400 kg.fed-1), Humic acid (5, 7 and 9 kg fed-1) and Fulvic acid (2, 3 and 4 kg fed-1)) compared with control treatment. Each treatment was replicated three times. The highest mean values of pea plants as fresh, dry weight (g), plant height (cm) and No. of leaves plant-1 also NPK% and its uptake mg plant-1 in plant foliage, N, P, K% and its uptake g plant-1, Fe ppm in pea seeds were significantly affected after 50 and 90 days during the season and obtained with using magnetite as material amendment at the rate of 300 kg fed-1 followed by using soil humic acid at the rate of 9 kg fed-1 compared with the other treatments. The same results were obtained with yield parameters (weight of 1000 seeds (g), fresh pods weight (g), fresh pods length and pea yield (g plant)-1 and seed quality (Total carbohydrates, Total sugar % and V.C (mg 100g) -1 which recorded the highest values with adding magnetite at the rate of 300 kg fed-1. In plant foliage, the highest values of Fe ppm was recorded with using magnetite as a source of iron at the rate of during both stages followed by using humic acid. As for Zn and Mn ppm recorded, the highest mean values with using fulvic acid at the low rate 2kg fed-1 comparing the all parameters with the control which recorded the lowest mean values of Fe, Zn and Mn ppm of plant foliage after. This trend was observed during both stages after 50 and 90 days.
Abstract from the paper’s OpenAlex record; open copy licensed cc-by. Read at the source ↗
The text the model read, with the source record’s inline markup (italics, sub- and superscripts) rendered and its character entities decoded; quote offsets refer to the raw text.
Claims 8
Claim · model-written summary
Magnetite at 300 kg fed-1 gave the highest pea biomass, height and leaf count.
- Taxon
- PEA PLANT
Lathyrus oleraceust0 - Treatment
- magnetite as material amendment at the rate of 300 kg fed-1e0
- Outcome
- fresh, dry weight (g), plant height (cm) and No. of leaves plant-1e0
- Direction
- higheste0
Not reportedComparator
Organisms pictured · Representative pictures of the matched species, not figures from the paper.
Verbatim
e0“The highest mean values of pea plants as fresh, dry weight (g), plant height (cm) and No. of leaves plant-1 also NPK% and its uptake mg plant-1 in plant foliage, N, P, K% and its uptake g plant-1, Fe ppm in pea seeds were significantly affected after 50 and 90 days during the season and obtained with using magnetite as material amendment at the rate of 300 kg fed-1”
t0“PEA PLANT”
Claim · model-written summary
Magnetite at 300 kg fed-1 maximized foliage and seed nutrient content and uptake.
- Taxon
- PEA PLANTLathyrus oleraceust0
- Treatment
- magnetite as material amendment at the rate of 300 kg fed-1e0
- Outcome
- NPK% and its uptake mg plant-1 in plant foliagee0
Not reportedComparatorDirection
Organisms pictured · Representative pictures of the matched species, not figures from the paper.
Verbatim
e0“NPK% and its uptake mg plant-1 in plant foliage, N, P, K% and its uptake g plant-1, Fe ppm in pea seeds were significantly affected after 50 and 90 days during the season and obtained with using magnetite as material amendment at the rate of 300 kg fed-1”
t0“PEA PLANT”
Claim · model-written summary
Humic acid at 9 kg fed-1 ranked next for the measured growth and nutrient traits.
- Taxon
- PEA PLANTLathyrus oleraceust0
- Treatment
- soil humic acid at the rate of 9 kg fed-1e0
- Outcome
- followed by using soil humic acide0
- Comparator
- other treatmentse0
Organisms pictured · Representative pictures of the matched species, not figures from the paper.
Verbatim
e0“followed by using soil humic acid at the rate of 9 kg fed-1 compared with the other treatments.”
t0“PEA PLANT”
Claim · model-written summary
Magnetite at 300 kg fed-1 gave the highest yield parameters.
- Taxon
- PEA PLANTLathyrus oleraceust0
- Treatment
- magnetite at the rate of 300 kg fed-1e0
- Outcome
- yield parameterse0
- Direction
- highest valuese0
Not reportedComparator
Organisms pictured · Representative pictures of the matched species, not figures from the paper.
Verbatim
e0“yield parameters (weight of 1000 seeds (g), fresh pods weight (g), fresh pods length and pea yield (g plant)-1 and seed quality (Total carbohydrates, Total sugar % and V.C (mg 100g) -1 which recorded the highest values with adding magnetite at the rate of 300 kg fed-1.”
t0“PEA PLANT”
Claim · model-written summary
Magnetite at 300 kg fed-1 gave the highest seed quality values.
- Taxon
- PEA PLANTLathyrus oleraceust0
- Treatment
- magnetite at the rate of 300 kg fed-1e0
- Outcome
- seed qualitye0
- Direction
- higheste0
Not reportedComparator
Organisms pictured · Representative pictures of the matched species, not figures from the paper.
Verbatim
e0“seed quality (Total carbohydrates, Total sugar % and V.C (mg 100g) -1 which recorded the highest values with adding magnetite at the rate of 300 kg fed-1.”
t0“PEA PLANT”
Claim · model-written summary
Magnetite produced the highest foliage Fe values at both stages.
- Taxon
- PEA PLANTLathyrus oleraceust0
- Treatment
- magnetitee0
- Outcome
- Fe ppme0
- Direction
- higheste0
Organisms pictured · Representative pictures of the matched species, not figures from the paper.
Verbatim
e0“In plant foliage, the highest values of Fe ppm was recorded with using magnetite as a source of iron at the rate of during both stages followed by using humic acid.”
t0“PEA PLANT”
Claim · model-written summary
Low rate fulvic acid gave the highest foliage Zn and Mn values.
- Taxon
- PEA PLANTLathyrus oleraceust0
- Treatment
- fulvic acid at the low rate 2kg fed-1e0
- Outcome
- highest mean valuese0
- Direction
- higheste0
Not reportedComparator
Organisms pictured · Representative pictures of the matched species, not figures from the paper.
Verbatim
e0“the highest mean values with using fulvic acid at the low rate 2kg fed-1”
t0“PEA PLANT”
Claim · model-written summary
Control plants had the lowest foliage Fe, Zn and Mn values.
- Taxon
- PEA PLANTLathyrus oleraceust0
- Treatment
- controle0
- Outcome
- Fe, Zn and Mn ppm of plant foliagee0
- Direction
- loweste0
Organisms pictured · Representative pictures of the matched species, not figures from the paper.
Verbatim
e0“the control which recorded the lowest mean values of Fe, Zn and Mn ppm of plant foliage”
t0“PEA PLANT”
The same questions in other papers
magnetite · growth · Lathyrus oleraceus (pea)Results agree
1 paper in the same direction as this paper
- positive
magnetite · yield · Lathyrus oleraceus (pea)Results agree
1 paper in the same direction as this paper
- positive
other · growth · Lathyrus oleraceus (pea)Positive and negative results
17 papers in the same direction as this paper · 2 in the opposite direction
- negative
- no effect
- positive
16 papers more in this group
See all 20 papers →other · nutrient: content · Lathyrus oleraceus (pea)Results agree
11 papers in the same direction as this paper
- positive
- positive
- positive
8 papers more in this group
See all 12 papers →Claims are grouped by organism, treatment and what was measured or targeted. A paper counts as positive when any of its claims in the group is positive.